Fastening The Table Plate To The Stand - Dürkopp Adler 667 Operating Instuructions

3.4 Fastening the table plate to the stand

7
6
6
Fig. 4
– Fasten stand 7 to table plate 2 by using wood screws (6x30). Pre-drill the
holes for the wood screws.
– Observe the centre mark for the stand (siehe Kapitel 3.2).
– Turn the stand 7 to its normal position.
– Attach the rod 3 to the pedal 5 and set value initiator.
– For ergonomic reasons align laterally the pedal 5 as follows:The centre of
the pedal must be approximately under the needle.Slots are provided in
the stand brace 4 to help align the pedal.
– Loosen screw 6.
– Adjust the height of the pedal linkage so that, when released, the pedal is
at an angle of approx. 10°.
– Tighten screw 6.
– Insert the reel stand 1 into the drilled hole in the table plate and secure in
place with a nut and washer.
– Mount and align the reel holder and unwinder arm.
– The reel holder and unwinder arm must be positioned on top of each
other.
3
4
5
1
2