Table of Contents
Advertisement
3.2 Completing the table plate for the MG 55-3 stand with direct drive
6
3.3 Creating the table plate
7
5
4
Fig. 3
– Turn over the table plate 8.
– Screw on the cable channel 1.
– Screw on the motor control unit 2.
– Screw on the power supply unit 3 (optional equipment).
– Screw on the knee switch 4 for the sewing-foot stroke.
– Screw on the set value initiator 5.
– Screw on the drawer 6 together with its fixtures.
– Screw on the sewing light transformer 7 (optional equipment).
– Assemble the electrical cable according to (see chapter 4) in these
instructions.
A larger scale illustration is available at the end of the manual.
If you are creating the table plate yourself, please refer to the illustrations at
the end of this manual for the measurements.
8
3
1
2
5
Advertisement
Chapters
Table of Contents
