Connecting The Da321G Control Unit; Connecting The Knee Switch - Dürkopp Adler 667 Operating Instuructions

4.3 Connecting the DA321G control unit

2
Fig. 17

4.4 Connecting the knee switch

14
B41
M
B2
M
B18
LSM...
1
– Insert the lead from the controller (pedal) into socket B80 of the control
unit.
– Insert the lead from the motor sensor 1 into socket B2 of the control unit.
– Insert the lead 2 from the motor into socket B41 of the control unit.
– Insert the lead to the sewing machine into socket A of the control unit.
– Lay all leads through the cable duct.
– Insert the lead from the control panel (if present) into socket B776.
– Insert the knee switch cable 3 into the KN19 socket on the front.
– Use the clips 4 to secure the cable 3 in place (667-180312 and 667-
180332 only).
3
B80
EB...
B776
4
V8 . .
A
Fig. 18
KN19