Status Message - Kenwood NX-3000 Series User Manual

STATUS MESSAGE

You can send and receive 2-digit Status messages which may be decided in your
talk group. Messages can contain up to 16 alphanumeric characters. Status
messages range from 10 to 99 (80 ~ 99 are reserved for special messages).
A maximum of 250 received messages can be stored in the stack memory of your
transceiver. These saved messages can be reviewed after reception. Depending on
your dealer settings, when the stack memory is full, either the oldest message will be
erased when a new message is received or the new message will not be stored in
the stack memory. The
memory.
Transmitting
o
1
Select your desired zone and channel.
2
Press the button programmed as [Status] to enter Status mode (proceed to step
5), or [Individual + Status]/ [Group + Status] to enter Selcall mode (proceed
to step 3).
3
Press the [J] and [K] buttons to select the station you want to call.
If Manual Dialing is enabled, you can enter the station ID by using the keypad on a full
●
button model Portable transceiver or on the microphone of a Mobile transceiver.
4
Press the [I] button to enter Status mode.
5
Press the [J] and [K] buttons to select the status you want to transmit.
If Manual Dialing is enabled, you can enter the status ID by using the keypad on a full
●
button model Portable transceiver or on the microphone of a Mobile transceiver.
6
Press the PTT switch to initiate the call.
"Complete" appears on the display when the status has been successfully transmitted.
●
Receiving
o
The indicator will flash and a calling ID and status message will appear when a
Status call is received. Press any button to return to normal operation.
Reviewing Messages in the Stack Memory
o
1
Press the button programmed as [Stack], or press and hold the button
programmed as [Individual], [Group], [Status], [Individual + Status], or
[Group + Status] to enter Stack mode.
The category list is displayed.
●
However, depending on the stack settings programmed by your dealer, the individual
list (Caller ID, Status Message or Short Message) may be displayed instead of the
category list. For details on the stack settings, consult your dealer.
The categories are identified as follows:
●
: Caller ID,
2
Press the [J] and [K] buttons to select the desired category, then press the [ ]
or [ ] button.
The Caller ID list, Status Message list or Short Message list is displayed according to
●
the category selected. Pressing the [H]/[I] buttons allows you to cycle the display
information as follows.
While Caller ID list is displayed:
–
[H]: Caller ID > CH > Time Stamp
[I]: Caller ID > Time Stamp > CH
48
indicator appears when a message is stored in the stack
: Status Message, : Short Message