Dtmf (Dual Tone Multi Frequency) Calls - Kenwood NX-3000 Series User Manual

DTMF (DUAL TONE MULTI FREQUENCY) CALLS

Note:
DTMF calls can be made only in Analog Conventional, NXDN (Conventional/ Trunking)
●
and LTR Trunking Operations.
Manual Dialing and Keypad Auto PTT are available only on full button model Portable
●
transceivers and Mobile transceivers with microphone with keypad.
MAKING A DTMF CALL
Manual Dialing
o
1
Press and hold the PTT switch.
2
Enter the desired digits using the DTMF or microphone keypad.
The corresponding DTMF tones sound each time you press a button.
●
If you release the PTT switch, transmit mode will end even if the complete number has
●
not been sent.
Keypad Auto PTT
o
If your dealer has activated the Keypad Auto PTT function, simply press the buttons
on the keypad or microphone to make the call.
The DTMF code will be sent automatically when you press a button.
●
Store & Send
o
1
Enter the desired digits using the DTMF or microphone keypad.
The digits appear on the display as you enter them.
●
You can enter digits by using the [J] and [K] buttons. Press these buttons to cycle
●
through the DTMF digits.
You can enter up to 34 digits before transmitting.
●
2
After entering the complete number, press the PTT switch to transmit.
Note:
If you switch the power OFF before transmitting the number, the number will be cleared.
●
Stun Code
o
This function is used when a transceiver is stolen or lost.
When the transceiver receives a call containing a stun code, either the transmit mode
or both the receive and transmit mode will be disabled. The stun code is canceled
when the transceiver receives a call with a revive code.
36