Kenwood NX-3000 Series User Manual page 29

Save Log Data <Log>
o
Allows you to save this transceiver's operation and communication logs.
Scan <Scan>
o
Refer to "SCAN" {p. 33} .
Scan Delete/ Add <D/A>
o
Allows you to include or omit each channel in the scan sequence.
Scan Normal <ScnNrm>
o
Allows you to forcibly perform a non-priority scan even when priority scan has been
set.
Scan Program <ScnPrg>
o
Allows you to reprogram the Scan List and Priority channels using your transceiver.
Refer to "SCAN PROGRAMMING" {p. 34} .
Scrambler/ Encryption <Scr/ Encryp>
o
Allows you to prevent a third party from listening in on your call. Refer to
"SCRAMBLER (ANALOG/ LTR)/ ENCRYPTION (NXDN/ DMR)" {p. 40} .
Scrambler/ Encryption Code
o
Allows you to change the scrambler code used in the transmission. Refer to
"SCRAMBLER (ANALOG/ LTR)/ ENCRYPTION (NXDN/ DMR)" {p. 40} .
Send the GPS Data <GPS_TX>
o
For Portable transceivers, this allows you to send your positioning data to the base
station when a GPS unit has been installed.
For Mobile transceivers, this allows you to send your positioning data to the base
station. However, the following must be noted.
When using the NX-3720G, NX-3720HG, NX-3820G, NX-3820HG, you must connect a
●
KRA-40 GPS antenna.
When using the NX-3720, NX-3720H, NX-3820, NX-3820H, you must connect an external
●
GPS unit.
When the power is turned ON and/or the reception condition of the GPS satellite is poor,
●
positioning may take longer to complete.
When using the built-in GPS Receiver, "GPS Ant Fail" appears on the display if the GPS
●
antenna is not connected or the connection is abnormal (e.g. short circuit).
Short Message <SDM>
o
Allows you to send short messages such as an address, telephone number, etc.
Site Down <Site－>
o
Press this button to decrease the site number.
Site Lock <SiteLk>
o
Allows you to lock the current site. The transceiver will not be able to search for
alternate sites, and "Site Lock" appears on the display.
29