5-Tone Signaling (For E Type Only) - Kenwood NX-3000 Series User Manual

5-TONE SIGNALING (For E type only)

5-tone Signaling is enabled or disabled by your dealer. This function opens the
squelch only when the transceiver receives the 5 tones programmed in your
transceiver. Transceivers that do not transmit the correct tones will not be heard.
SELCALL (SELECTIVE CALLING)
A Selcall is a voice call to a station or group of stations.
Transmitting
o
1
Select your desired zone and channel.
2
Press the button programmed as [Individual]/ [Individual + Status]/
[Individual + Short Message]/ [Group]/ [Group + Status]/ [Group + Short
Message] to enter Selcall Mode.
Alternatively, press the button programmed as [Menu] to enter Selcall Mode using
Individual/ Individual + Status/ Individual + Short Message/ Group/ Group + Status/ Group
+ Short Message in the Menu Mode.
3
Press the [J] and [K] buttons to select the station you want to call.
If Manual Dialing is enabled, you can enter the station ID by using the keypad on a full
●
button model Portable transceiver or on the microphone of a Mobile transceiver.
4
Press the button programmed as [Call 1] to [Call 6] and begin your conversation.
Note:
You can also use the buttons programmed as [Digit 1x Down], [Digit 1x Up], [Digit 10x
●
Down], and [Digit 10x Up] to adjust the Selcall number. [Digit 1x Up] and [Digit 1x
Down] increases and decreases the Selcall number by 1 respectively each time the button
is pressed. [Digit 10x Up] and [Digit 10x Down] increases and decreases the Selcall
number by 10 respectively each time the button is pressed.
Receiving
o
When a call containing the correct tones is received, the transceiver will enter Selcall
mode. An alert tone will sound and the calling station's ID appears on the display.
Press any button to return to normal operation.
STATUS MESSAGE
You can send and receive Status messages which may be decided in your talk group.
Messages can contain up to 16 alphanumeric characters.
A maximum of 250 received messages can be stored in the stack memory of your
transceiver.
Transmitting
o
1
Select your desired zone and channel.
2
Press the button programmed as [Status] to enter Status mode (proceed to step
5), or [Individual + Status]/ [Group + Status] to enter Selcall mode (proceed
to step 3).
50