Character Entry - Kenwood NX-3000 Series User Manual

CHARACTER ENTRY

While in the character entry screen, you can use the following two methods to enter
the characters:
Pressing the [J]/[K] buttons
o
Press [J]/[K] to cycle the characters from A ~ Z, a ~ z, 0 ~ 9, and a space (default
settings).
You can also assign a character to an optional button and later press that button to
recall the assigned character: A ~ Z, a ~ z, 0 ~ 9, or a space and characters.
You can enter characters using the [J]/[K] buttons when the buttons function as character
●
input buttons. When the buttons function as line up/ down buttons, it is not possible to enter
a character.
Using the keypad
o
(Full button model Portable transceivers and Mobile transceivers with
microphone with keypad only)
Press the keypad buttons to enter characters as shown in the table below.
You can press the [ ] button repeatedly to switch the input mode (upper case B lower
case B numbers B back to beginning).
Keypad Character Cycle (Upper Case)
1 @ # " ( ) ! $ _
2 A B C
3 D E F
4 G H I
5 J K L
6 M N O
7 P Q R S
8 T U V
9 W X Y Z
0 (space) . , ? / ' &
20
Character Cycle (Lower Case)
@ # " ( ) ! $ _
a b c
d e f
g h i
j k l
m n o
p q r s
t u v
w x y z
(space) . , ? / ' &