Status Message - Kenwood NX-700 Instruction Manual

■ Identifi cation Codes
An ID code is a combination of a 3-digit Fleet number and a 4-digit ID number.
Each transceiver must have its own Fleet and ID number.
• Enter a Fleet number (100 ~ 349) to make a group call.
• Enter an ID number (1000 ~ 4999) to make an individual call in your fl eet.
• Enter a Fleet number to make a call to all units in the selected fl eet (Fleet call).
• Enter an ID number to make a call to the selected ID in all fl eets (Supervisor call).
• Select "ALL" Fleet and "ALL" ID to make a call to all units (Broadcast call).
Note:
◆ Broadcast and Supervisor calls are programmed functions that cannot be made with a keypad.
◆ The ID range may be limited by programming.

STATUS MESSAGE

You can send and receive 2-digit Status messages which may be decided in your
talk group. Messages can contain up to 16 alphanumeric characters. Status
messages range from 10 to 99 (80 ~ 99 are reserved for special messages).
A maximum of 15 received messages can be stored in the stack memory of your
transceiver. These saved messages can be reviewed after reception. Depending
on your dealer settings, when the stack memory is full, either the oldest message
will be erased when a new message is received or the new message will not be
stored in the stack memory. The
stack memory.
■ Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as Status to enter Status mode or Selcall +
Status to enter Selcall mode.
• When using the Status key to enter Status mode, the target Fleet/ ID is fi xed and
cannot be selected. Skip to step 5 to continue.
3 In Selcall mode, press the
to call.
• If Manual Dialing is enabled, you can enter the station ID by using the
microphone keypad, or by using
cycle through the digits to select a digit, then press the
the digit and move the cursor to the right. Repeat this process until the
entire ID is entered.
4 Press the
5 Press the
• If Manual Dialing is enabled, you can enter the station ID by using the
microphone keypad, or by using
cycle through the digits to select a digit, then press the
the digit and move the cursor to the right. Repeat this process until the
entire ID is entered.
18
/
key enter Status mode.
/ keys to select the status ID you want to transmit.
icon lights when a message is stored in the
keys to select the ID of the station you want
the / keys. When using the
the / keys. When using the
/ keys,
key to set
/ keys,
key to set