Kenwood NX-3000 Series User Manual page 63

Device Class
Audio/Video
Phone
Computer
LAN/Network
Peripheral
Imaging
Wearable
Toy
Health
Note:
You can also check the information of the devices in the Find Device mode.
●
The icons listed in the above table indicate the connection status of the Headset Profile.
●
They are not applicable to the Serial Port Profile connection.
Switching the speaker audio output
o
You can switch the audio output between the speaker of the transceiver and the
Bluetooth headset.
Portable
Press the button programmed as [Bluetooth Speaker] to change the setting ("Off"
or "Only").
Alternatively, press the button programmed as [Menu] to enter Bluetooth Speaker
Mode using the Menu Mode. Press the [J] and [K] buttons to select "Off" or "Only".
Off : Audio is output from the built-in speaker of the transceiver.
Only : Audio is output from the speaker of the Bluetooth device.
Press the [ ] button to confirm your selection.
Mobile
Press the button programmed as [Bluetooth Speaker] repeatedly to change the
setting ("Off", "Only" or "Both(BT+Radio)").
Alternatively, press the button programmed as [Menu] to enter Bluetooth Speaker
Mode using the Menu Mode. Press the [J] and [K] buttons to select "Off", "Only" or
"Both(BT+Radio)".
Off
Only
Both(BT+Radio) : Audio is output from both built-in speaker of the transceiver and
Press the [ ] button to confirm your selection.
: Audio is output from the built-in speaker of the transceiver.
: Audio is output from the speaker of the Bluetooth device.
speaker of the Bluetooth device.
Disconnected Connected
63