Kenwood NX-3000 Series User Manual page 24

Channel Down <CH－>
o
Press this button to decrease the channel number. {p. 4}
Channel Entry <CH_Ent>
o
Press this button to enter Channel Entry Mode, to select a channel.
Channel Information <ChInfo>
o
Allows you to cycle through the display information as follows: Channel name > Zone-
channel number > Frequency > QT/DQT > RAN
Channel Recall <CH_Rcl>
o
Press this button during Scan to return to the last called zone and channel.
Channel Up <CH+>
o
Press this button to increase the channel number. {p. 4}
Clear <Clear>
o
Press this button to end a call or cancel a data transmission.
Clock <Clock>
o
Refer to "CLOCK" {p. 44} .
Clock Adjustment <ClkAdj>
o
Allows you to set the clock. Refer to "CLOCK" {p. 44} .
CW Message <CW_Msg>
o
Press this button to send the CW message.
Digit 10x Down <10x->
o
Press this button to decrease the Selcall number by 10 with each press.
Digit 10x Up <10x+>
o
Press this button to increase the Selcall number by 10 with each press.
Digit 1x Down <1x->
o
Press this button to decrease the Selcall number by 1 with each press.
Digit 1x Up <1x+>
o
Press this button to increase the Selcall number by 1 with each press.
Direct Channel 1 ~ 5 <DR1 ~ DR5>
o
Press one of these buttons to jump to a frequently used zone and channel (pre-
programmed by your dealer). If activated by your dealer, you can set your own Direct
Channels by selecting your desired zone and channel using Direct Channel 1 ~ 5
Select.
Direct Channel 1 ~ 5 Select
o
Allows you to set the currently selected zone and channel as the Direct Channel 1 ~
5.
24