Kenwood NX-3000 Series User Manual page 51

3
Press the [J] and [K] buttons to select the station you want to call.
If Manual Dialing is enabled, you can enter the station ID by using the keypad on a full
●
button model Portable transceiver or on the microphone of a Mobile transceiver.
4
Press the [I] button to enter Status mode.
5
Press the [J] and [K] buttons to select the status you want to transmit.
If Manual Dialing is enabled, you can enter the status ID by using the keypad on a full
●
button model Portable transceiver or on the microphone of a Mobile transceiver.
6
Press the button programmed as [Call 1] to [Call 6] to initiate the call.
Receiving
o
The indicator will flash and a calling ID and status message will appear when a
Status call is received. Press any button to return to normal operation.
Reviewing Messages in the Stack Memory
o
1
Press the button programmed as [Stack] to enter Stack mode.
The category list is displayed.
●
The categories are identified as follows:
●
: Caller ID,
2
Press the [J] and [K] buttons to select the desired category, then press the [ ]
or [ ] button.
The Caller ID list, Status Message list or Short Message list is displayed according to
●
the category selected. Pressing the [H]/[I] buttons allows you to cycle the display
information as follows.
While Caller ID list is displayed:
–
[H]: Caller ID > CH > Time Stamp
[I]: Caller ID > Time Stamp > CH
While Status Message list or Short Message list is displayed:
–
[H]: Message > Caller ID > CH > Time Stamp
[I]: Message > Time Stamp > CH > Caller ID
To delete the selected message, press the [
●
press and hold the [
3
Press [ ] to return to normal operation.
: Status Message,
] or [#] button for 1 second.
: Short Message
] or [#] button. To delete all messages,
51