How To Install The Handle Kit (Option 1Cn) - Agilent Technologies ENA Series Installation And Quick Start Manual

Installation
Installing Front Handles/Rack Mounting Flanges
Figure 2-4 Installing front handle/rack-mount kits

How to Install the Handle Kit (Option 1CN)

The handle kit is used for transport and relocation of the E5061A/E5062A. While referring
to Figure 2-4, install the handle kit by following these steps.
Step 1. Remove the adhesive-backed trim strip (1) from each side of the outer frame of the
E5061A/E5062A front panel.
Step 2. Use the provided screws to mount the front handles (2) on each side of the
E5061A/E5062A front panel frame.
Step 3. Attach the provided modified trim strip (3) to each front handle in order to cover the front
panel locking screws.
WARNING
If the installed front handle becomes damaged, replace it with a new one immediately.
A damaged handle can break while moving or lifting the instrument and cause
personal injury or damage to the instrument.
22 Chapter 2