To Split The Display Graticule; To Make List Sweep; To Create Sweep List - Agilent Technologies E5100A User Manual

To split the display graticule

Note

To make list sweep

To create sweep List

5-4 Analyzer Feature T utorial
1. Press
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
SPLIT DISP to change
4 5
Display
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
SPLIT DISP ON off .
2. The graticule for channel 1 and channel 2 is split one over another.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
With COUPLED CH OFF , the stimulus values of each channels depends
on the number of channels as describes below.
NUM of CH When
2 Ch1 and Ch2 can have di erent stimulus.
3 Ch1 and Ch2 have same stimulus. Ch3 can have
di erent stimulus from Ch1 and Ch2.
4 Ch1 and Ch2 have same stimulus, and Ch3 and
Ch4 have same stimulus. Ch1 and Ch2 can have
di erent stimulus from Ch3 and Ch4.
The analyzer has a list sweep function which can sweep frequency
according to a prede ned sweep segment list. Each sweep segment is
independent and can have a di erent number of sweep points, power
level, and IF bandwidth value. A segment looks like a normal stimulus
sweep setting, and the list sweep function can combine up to 801
total sweep points into one sweep. The analyzer can have 2 di erent
sweep lists (list 1 and list 2). Either one can be used, or both can be
used for 2 channels (under the Coupled channel o condition). This
section describes the following three applications:
Sweep time reduction for lter testing (with setup procedure)
Dynamic range enhancement
Use of order base display mode
The following is an example of creating a list sweep to measure a
lter that has a 70 MHz center frequency and a 20 kHz bandwidth.
This example uses the list sweep to reduce the sweep time by setting
coarse sweep points for the rejection band and ne sweep points for
the passband.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
1. Press
SWEEP TYPE MENU
4 5
Sweep
2. The list table editor is displayed.
3. Con rm that the cursor positions at (SEG1, START).
4. Press
4 5 4 5 4 5 4 5
6 9 . 9
5. Press !
NNNNNNN
to move the cursor to the right cell.
6. Press
4 5 4 5 4 5 4 5 4
6 9 . 9
7. Press !
NNNNNNN
to move the cursor to the right cell.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
SPLIT DISP on OFF to
is OFF:
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
COUPLED CH
NNNNNNNNNNNNNN
MORE
NNNNNNNNNNN
x M .
NNNNNNNNNNN
x M .
5
6
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
LIST EDITOR .