To Make Response Calibration; To Measure Dut; To Display The Trace Of All Channel - Agilent Technologies E5100A User Manual

To make response calibration

To measure dut

To display the trace of all channel

6. Press
4 5 4 5 4
Center 7
7. Press
4 5 4 5 4 5 4
Span 5 0
8. Press
4
Meas/Format
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
ACTIVE CH [CH2] .
9. Press
4
Meas/Format
10. Press
NNNNNNNNNNNNNNNNNNNN NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
LOGMAG & PHASE .
FORMAT
11. Press
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
SWEEP TYPE MENU
4 5
Sweep
12. Press
4 5 4 5 4 5 4
Start - 6
13. Press
NNNNNNNNNNN
x 1 .
4 5 4 5
Stop 0
1. Connect that thru between input R and input A.
2. Press
NNNNNNNNNNNNNNNNNNNNNNNNNN
RESPONSE
4 5
Cal
3. The
NNNNNNNNNNNNNN
THRU softkey label is underlined when the measurement is
completed.
4. Press
NNNNNNNNNNNNNNNNN
DONE: .
1. Connect dut between input R and input A.
2. Select
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
ACTIVE CH [CH1] to observe the trace for channel 1.
3. Press
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
AUTO SCALE to scale automatically.
4 5
Display
4. Select
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
ACTIVE CH [CH2] to observe the trace for channel 2.
5. Press
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
AUTO SCALE to scale automatically.
4 5
Display
1. Press
NNNNNNNNNNNNNNNNNNNNNNNNNN
MULTI CH to change
4 5
Display
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
MULTI CH ON off .
2. The all traces of channel 1 and channel 2 are displayed.
NNNNNNNNNNN
x M .
5
0
NNNNNNNNNNN
x k .
5
0
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
ACTIVE CH [CH1] to change to
5
NNNNNNNNNNNNNN NNNNNNNNNNN
A/R .
MEAS
5
NNNNNNNNNNNNNNNNN
POWER .
NNNNNNNNNNN
x 1 .
5
0
NNNNNNNNNNNNNN
THRU .
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
MULTI CH on OFF to
Analyzer Feature T utorial 5-3