Reference Level; Marker Data Readout; Marker Stimulus; Trace Number - Agilent Technologies E5100A User Manual

6. Reference Level

7. Marker Data Readout

8. Marker Stimulus

9. Trace number

10. Service Notation

11. Stimulus Value

12. Sweep Notations

13. Reference Position

14. Status Notations

Displays the value of a reference line in Cartesian formats. It is
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
selected using SCALE MENU under the
reference line is invisible (it is indicated by a small triangle adjacent
to the graticule at the left).
Displays the values of the marker in units appropriate to the current
measurement.
Displays the stimulus value of the marker.
Indicates the trace number for the measurement trace.
Indicates the analyzer is in service mode or self test was failed. See
E5100A/B Service Manual
Displays the start/stop or the center/span values of frequency or
power.
Displays one of the following the sweep conditions:
Hold sweep ( FFFFFFFFFFFF
Hld HOLD
Wait external trigger (
Ext
Under sweep
"
Stimulus parameters changed: measured data in doubt until a complete
*
fressh sweep has been taken.
Indicates the reference position.
Displays the current status of various functions for each channels.
The following notations are used:
Error correction is on (
Cor
Stimulus parameters have changed, and interpolated error correction is
C?
on.
Stimulus parameters have changed, and interpolated error correction is
C!
not available.
Electrical delay or phase o set has been added or subtracted
Del
FFFFFFFFFFFFFFFFFFFFFFFFFF
(
SCALE MENU
Trace smoothing is on (
Smo
For example, the upper Cor in Figure 2-2 is for channel 1 and the
lower one is for channel 2.
4
Display
under the key).
Trigger
4 5
FFFFFFFFFFFFFFFFFFFFFFFFFF under the
TRIG EVENT
FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF
Correction on OFF
under the key).
Display
4 5
FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF
SMOOTHING on OFF
key. However, the
5
key).
Trigger
4 5
under the key).
Cal
4 5
under the key).
Display
4 5
Front and Rear Panel 2-5