To Save Le To A Ram Disk; To Recall A Le - Agilent Technologies E5100A User Manual

Note
To save le to a RAM disk
Note
To recall a le
Note
Saving DATA ONLY won't allow the recall of operating parameters
such as start/stop frequency, list sweep tables and limit lines. You
must save state only or a ALL for this information.
9. Press
, and select
4 5
Save/Recall
that key
10. Press
4 5
Save/Recall
11. The instrument will save the le to the current working directory
of RAM disk. If you want to save the le in another directory,
move the working directory. Refer to \To change working
directory".
12. When both instrument state and measurement data are to be
NNNNNNNNNNN
saved, press ALL . When only the instrument state is to be saved,
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
press STATE ONLY . When only binary format measurement
data is to be saved, press
only ASCII format measurement data is to be saved, press
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
DATA ONLY (ASCII) .
13. Select letters for the input le name.
14. After entering the le name, press
15. When you want to use all les in the RAM disk after power on
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
again, press BACKUP MEMO DISK .
Saving DATA ONLY won't allow the recall of operating parameters
such as start/stop frequency, list sweep tables and limit lines. You
must save state only or a ALL for this information.
At power on, all les in the FLASH disk copy to the RAM disk.
1. Press
NNNNNNNNNNNNNNNNNNNN
RECALL to display the le names in the center of
4 5
Save/Recall
display.
2. Change the working directory when you want to save a le to
another directory. Refer to \To change working directory".
3. Select the le name you want to recall using arrow keys, and then
press . If you can not nd the le name you want to select,
4 5
ENTER
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
press NEXT PAGES or
The le names are labeled with the following le type identi cation
extensions after the le name:
NNNNNNNNNNNNNN
.ALL : means all (instrument state and measured data:binary)
NNNNNNNNNNNNNN
.STA : means instrument state only (BINARY).
NNNNNNNNNNNNNN
.DAT : means measured data only (BINARY).
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
STORE DEV [B:MEMO] by pressing
NNNNNNNNNNNNNN
SAVE .
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
DATA ONLY (BINARY) . When
NNNNNNNNNNNNNN
DONE to complete this task.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
PREV PAGES until the le name is displayed.
Analyzer Feature T utorial 5-9