Table of Contents
Advertisement
3
FEATURES AND OPERATION
3.1
OVERVIEW
This chapter describes the connections, indicators, and operating characteristics of the Integra-TR. This chapter is intended
for system application and installation personnel.
3.2
FRONT PANEL
The various front panel elements are described in the following sections.
3.2.1 ANTENNA CONNECTOR
Antenna connector is a female 50-ohm SMA- type. Units operated with a "rubber duck" antenna connected directly to the
antenna connector may exhibit unusual operating characteristics and high levels of reverse power.
3.2.2 CONNECTION TO DTE
Integra-TR is configured as DCE. Most DTE devices should be connected using a nine-conductor pin-to-pin "straight" cable
(CalAmp part number 697-4008-408). Some RTUs or PLCs may require a special cable to route the signals correctly. See the
documentation for your data equipment for further information. Contact CalAmp for DTE interface information or review
CalAmp's Technical Services Application Notes available on our website at www.calamp.com.
3.2.3 LED INDICATORS
Integra-TR has four two-color LED indicators. Their functions are shown in Table 3.
Integra-TR User Manual
Page | 20
Advertisement
Table of Contents
