Table of Contents
Advertisement
17 LIGHTING SYSTEM, INSTRUMENTS
140
- Wait for the menu TIRE to flash.
Reducing the wheel circumference
-
Press the left button.
y The value decreases.
Enlarging the wheel circumference
-
Press the right button.
y The value increases.
XU
7 I \> n
' i r (uu
401910-01
Finishing work
- Unplug combination instrument connector DR.
Checking the headlight setting
17.2
Position the vehicle upright on a horizontal surface in front of a light wall and
make a mark at the height of the center of the low beam headlight.
Make another mark at a distance © under the first mark.
Guideline
©
©t
Distance ©
5 cm (2 in)
Position the vehicle vertically at a distance
o
away from the wall.
Guideline
Distance
o
5 m (16 ft)
400726-10
The rider, with luggage and passenger if applicable, now mounts the motorcycle.
Switch on the low beam.
Check the headlight setting.
The light-dark boundary must lie exactly on the lower mark when the motor
cycle is ready to operate with the rider mounted along with any luggage and a
passenger if applicable.
If the boundary between light and dark does not meet specifications:
- Adjust the headlight range. (Hi p. 140)
17.3
Adjusting the headlight range
Preparatory work
-
Check the headlight setting. ( p. 140)
Main work
-
Loosen screw ©.
-
Adjust the headlight range by pivoting the headlight.
Guideline
M
o
The boundary between light and dark must be exactly on the lower mark for
a motorcycle with rider (instructions on how to apply the mark: Checking the
headlight setting).
Info
If you have a payload, you may have to correct the headlight range.
I
V00504-10
Tighten screw Q.
Advertisement
Table of Contents
