15.10
Checking the headlight setting
15.11
Adjusting the headlight range
–
Insert the screw and first turn counterclockwise until it
engages in the thread with a small jerk. Tighten the screw
lightly.
Finishing work
–
Check that the turn signal system is functioning properly.
–
Position the vehicle upright on a horizontal surface in front of
a light wall and make a marking at the height of the center of
the low beam headlight.
–
Make another mark at a distance
Guideline
B
Distance
–
Position the vehicle vertically at a distance
wall.
400726-10
Guideline
A
Distance
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on
the lower mark for a motorcycle with rider.
»
If the boundary between light and dark does not meet
specifications:
–
Adjust the headlight range. (
Preparatory work
–
Check the headlight setting. (
Main work
–
Loosen screw
–
Adjust the headlight range by pivoting the headlight.
Guideline
The boundary between light and dark must be exactly on
the lower mark for a motorcycle with rider (instructions on
how to apply the mark: Checking the headlight setting).
Info
H03755-10
A change in weight on the vehicle may require a cor-
rection of the headlight range.
–
Tighten screw
ELECTRICAL SYSTEM 15
B
under the first marking.
5 cm (2 in)
5 m (16 ft)
p. 119)
p. 119)
1
.
1
.
A
away from the
119