15
ELECTRICAL SYSTEM
15.9
Checking the headlight setting
15.10
Adjusting the headlight range
15.11
Changing the speedometer battery
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark at a distance
Guideline
Distance
–
Position the vehicle vertically a distance
Guideline
Distance
400726-10
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with rider.
»
If the light-dark border does not meet specifications:
–
Adjust the headlight range. (
Preparatory work
–
Check the headlight setting. (
Main work
–
Loosen screw
–
Adjust the headlight range by pivoting the headlight.
Guideline
The boundary between light and dark must be exactly on the lower marking for
a motorcycle with rider (instructions on how to apply the marking: Checking the
headlight setting).
Info
V00369-10
If you have a payload, you may have to correct the headlight range.
–
Tighten screw
Preparatory work
–
Remove the headlight mask with the headlight. (
Main work
–
Remove screws
–
Pull the speedometer upward out of the holder.
V00370-10
–
Using a coin, turn protection cap
–
Remove speedometer battery
–
Insert the new battery with the label facing upward.
Speedometer battery (CR 2430) (
–
Check the O-ring of the protection cap for correct seating.
V00371-10
p. 97)
.
.
.
.
under the first mark.
5 cm (2 in)
away from the wall.
5 m (16 ft)
p. 97)
p. 94)
all the way counterclockwise and remove it.
p. 127)
97