Removing The Engine Guard - Husqvarna TX 125 Owner's Manual

12.45

Removing the engine guard

12 SERVICE WORK ON THE CHASSIS
–
Move the clutch fluid reservoir mounted on the handlebar to a
horizontal position.
–
Remove screws
–
Remove cover
V01010-10
–
Fill bleeding syringe
Syringe (50329050000)
Brake fluid DOT 4 (
–
On the slave cylinder, remove bleeder screw
bleeding syringe
S01343-10
–
Now press the fluid into the system until it emerges from the
6
hole of the master cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
–
Remove the bleeding syringe. Mount and tighten screws
bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
F00324-10
rim
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
–
Remove screws
H01655-01
1
.
2 3
with membrane .
4
with the appropriate hydraulic fluid.
p. 150)
4
.
4 mm (0.16 in)
1
and engine guard.
5
and mount
83