Husqvarna TX 125 Owner's Manual page 97

–
Stand the vehicle upright.
–
Remove the cable ties on the frame protector.
–
Remove screw cap
K00947-10
–
Manually press the brake caliper to the brake disc to push
back the brake piston. Ensure that brake fluid does not flow
out of the brake fluid reservoir, extracting it by suction if it
does.
Info
Make sure when pushing back the brake piston that
you do not press the brake caliper against the spokes.
–
Remove cotter pin
V00918-10
–
Push leaf spring
–
Remove brake linings.
–
Clean the brake caliper and brake caliper support.
–
Check that leaf spring
plate 6 in the brake caliper support are seated correctly.
K00948-10
–
Insert the new brake linings.
–
5
Mount pin
Leaf spring
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
the piston side brake lining.
H02370-10
–
Mount cotter pins
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
13 BRAKE SYSTEM
1 2
with membrane
3
.
4
downwards and remove pin
4
in the brake caliper and sliding
.
4
engages in the groove on the pin.
7
3
.
and the shim.
5
.
is mounted on
95