Recommended Work - Husqvarna TX 125 Owner's Manual

10 SERVICE SCHEDULE
Check the cables for damage and for routing without kinks.
Check that the throttle cables are undamaged, routed without sharp bends, and set
correctly.
Clean the air filter and air filter box.
Change glass fiber yarn filling in the main silencer.
Service the fork.
Service the shock absorber.
Check the screws and nuts for tightness.
Check the headlight setting. (
Check idle.
Final check: Check the vehicle for operating safety and take a test ride.
Make the service entry in the Husqvarna Motorcycles Dealer.net and in the Service
and Warranty Booklet.
○
One-time interval
●
Periodic interval
10.3
Change the front brake fluid.
Change the rear brake fluid.
Change the hydraulic clutch fluid.
Grease the steering head bearing.
Service the fork.
Service the shock absorber.
Check the starter drive.
Check/adjust the carburetor components.
Change the piston and check the cylinder.
Change the piston and check the cylinder.
Perform minor engine service. (Check the reed valve housing, reed valve, and
intake flange. Check the exhaust control for functioning and smooth opera-
tion. Check the clutch.)
Perform major engine service including removing and installing the engine.
(Change the connecting rod, conrod bearing, and crank pin. Check the trans-
mission and shift mechanism. Change all engine bearings.)
○
One-time interval
●
Periodic interval
42
(
p. 109)

Recommended work

(
(
(TE 150 US)
Every 10 operating hours when used for motorsports
Once after 5 operating hours
Once after 1 operating hour
p. 68)
( p. 70)
Every 40 operating hours when used for motorsports
Every 10 operating hours when used for motorsports
Every 40 operating hours
Once after 20 operating hours
Once after 10 operating hours
p. 82)
p. 60)
(TX 125 EU)
(TE 150 US)
Every 40 operating hours
Every 20 operating hours
○
○
○
○
○ ○
○ ○
Annually
Every 80 operating hours
○
○
● ●
●
● ●
●
● ●
●
● ● ●
● ● ●
● ● ●
● ●
●
●
● ● ●
● ● ●
● ● ●
● ● ●
● ● ●
●
●
●
●
● ●
● ●
● ●
●
● ●
●