Installing The Fork Legs - Husqvarna TX 125 Owner's Manual

12.6

Installing the fork legs

12 SERVICE WORK ON THE CHASSIS
–
Loosen screws
–
Loosen screws
V01005-10
Main work
–
Position the fork legs.
Bleeder screws
Info
The rebound damping is located in the right fork leg
(red adjusting screw). The compression damping is
located in the left fork leg (white adjusting screw).
Grooves are milled into the side of the upper end of
402556-10
the fork legs. The second milled groove (from the top)
must be flush with the top edge of the upper triple
clamp.
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Tighten screws
Guideline
Screw, bottom triple
clamp
V01005-11
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
brake caliper
–
Mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and
tighten screws
V00930-10
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
3
. Take out the left fork leg.
4
. Take out the right fork leg.
1
are positioned toward the front.
2 .
M8 17 Nm (12.5 lbf ft)
3
.
M8 15 Nm (11.1 lbf ft)
M8 25 Nm (18.4 lbf ft)
5
.
( p. 98)
p. 109)
4
.
®
Loctite 243™
p. 108)
55