Setting The Alarm Function; Battery Indicator And Battery Change; Batteries Almost Flat - Microlife BP W100 Instructions Manual

button. To permanently clear the memory, press the M-button while
«CL» is flashing. Individual values cannot be cleared.

6. Setting the Alarm Function

This instrument allows you to set 2 alarm times at which an alarm
signal will then be triggered. This can be a useful aid, for instance as
a reminder to take medication.
1. To set an alarm time, press the time button 6 (the instrument
must have been switched off beforehand) and immediately after-
wards the M-button 5 and hold both down until the bell symbol
AK appears in the bottom left of the display. Then release both
buttons. The flashing «1» in the display indicates that the first
alarm time can now be set.
2. Press the time button to set the hours – the hour display flashes
and pressing the M-button allows you to set the alarm hour. To
confirm, press the time button.
3. The minute display will now flash. The minutes can be set using
the M-button. To confirm, press the time button again.
4. The bell symbol will now flash. Use the M-button to select
whether the alarm time is to be active (bell) or inactive (crossed-
out bell). To confirm, press the time button.
BP W100
To set a second alarm time, proceed as above but if the «1»
flashes, press the M-button to select «2» and confirm with the
time button.
An active alarm time is indicated by the bell symbol in the display.
The alarm will sound at the set time every day.
To switch-off the alarm when it is sounding, press the ON/OFF
button 1.
To permanently switch off the alarm, proceed as above and select
the crossed-out bell symbol. This will then disappear from the
display.
The alarm times must be re-entered each time the batteries are
replaced.

7. Battery Indicator and Battery change

Batteries almost flat

When the batteries are approximately ¾ used the battery symbol AO
will flash as soon as the instrument is switched on (partly filled
battery displayed). Although the instrument will continue to measure
reliably, you should obtain replacement batteries.
7 EN