How Not To Store A Reading; Setting The Alarm Function; Battery Indicator And Battery Change; Low Battery - Microlife BP W100 Manual

How not to store a reading

As soon as the reading is displayed press and hold the ON/OFF
button 1 until «M» AL is flashing. Confirm to delete the reading by
pressing the M-button 5.

7. Setting the Alarm Function

This device allows you to set 2 alarm times at which an alarm signal
will then be triggered. This can be a useful aid, for instance as a
reminder to take medication.
1. To set an alarm time, press the time button 6 (the device must
have been switched off beforehand) and immediately afterwards
the M-button 5 and hold both down until the bell symbol AK
appears in the bottom left of the display. Then release both
buttons. The flashing «1» in the display indicates that the first
alarm time can now be set.
2. Press the time button to set the hours – the hour display flashes
and pressing the M-button allows you to set the alarm hour. To
confirm, press the time button.
3. The minute display will now flash. The minutes can be set using
the M-button. To confirm, press the time button again.
4. The bell symbol will now flash. Use the M-button to select whether
the alarm time is to be active (bell) or inactive (crossed-out bell).
To confirm, press the time button.
BP W100
To set a second alarm time, proceed as above but if the «1» flashes,

press the M-button to select «2» and confirm with the time button.
An active alarm time is indicated by the bell symbol in the display.

The alarm will sound at the set time every day.

To switch-off the alarm when it is sounding, press the ON/OFF

button 1.
To permanently switch off the alarm, proceed as above and select the

crossed-out bell symbol. This will then disappear from the display.
The alarm times must be re-entered each time the batteries are

replaced.

8. Battery Indicator and Battery change

Low battery

When the batteries are approximately ¾ empty the battery symbol AO
will flash as soon as the device is switched on (partly filled battery
displayed). Although the device will continue to measure reliably, you
should obtain replacement batteries.
Flat battery – replacement
When the batteries are flat, the battery symbol AO will flash as soon
as the device is switched on (flat battery displayed). You cannot take
any further measurements and must replace the batteries.
1. Open the battery compartment 3 by pulling off the cap.
7 EN