Memory Full; How Not To Store A Reading; Setting The Alarm Function - Microlife aponorm Mobil Plus Manual

Memory full

When the memory has stored 200 results, the display shows
When the memory has stored 99 results (99 memories per
«Full M» after a measurement. From this point onwards, a
user), the memory is full. From this point onwards, a new
measured value is stored by overwriting the oldest value.
Clear all values of an individual user
The following procedure applies to the user selected, 1 or 2. If you
are sure that you want to permanently remove all stored values,
hold down the M-button (the instrument must have been switched
off beforehand) until «CL» appears and then release the button.
To permanently clear the memory, press the M-button while «CL»
is flashing. Individual values cannot be cleared.

How not to store a reading

1
Press the ON/OFF button
Keep the button pressed until «M»
it. Confirm by pressing the M-button.

6. Setting the Alarm Function

7.
This instrument allows you to set 2 alarm times at which an alarm
signal will then be triggered. This can be a useful aid, for instance as
a reminder to take medication.
1. To set an alarm time, press the time button 6 (the instrument
must have been switched off beforehand) and immediately after-
wards the M-button 5 and hold both down until the bell symbol
20
while the reading is being displayed.
AL
is flashing and then release
AK appears in the bottom left of the display. Then release both
buttons. The flashing «1» in the display indicates that the first
alarm time can now be set.
2. Press the time button to set the hours – the hour display flashes
and pressing the M-button allows you to set the alarm hour. To
confirm, press the time button.
3. The minute display will now flash. The minutes can be set using
the M-button. To confirm, press the time button again.
4. The bell symbol will now flash. Use the M-button to select
whether the alarm time is to be active (bell) or inactive (crossed-
out bell). To confirm, press the time button.
To set a second alarm time, proceed as above but if the «1»
flashes, press the M-button to select «2» and confirm with the
time button.
An active alarm time is indicated by the bell symbol in the display.
The alarm will sound at the set time every day.
To switch-off the alarm when it is sounding, press the ON/OFF
button 1.
To permanently switch off the alarm, proceed as above and select
the crossed-out bell symbol. This will then disappear from the
display.
The alarm times must be re-entered each time the batteries are
replaced.
aponorm ® by