Advertisement
display will close without any operation for I min. Once selected, press the ENTER
button to setup or exit menu mode without any change after 30 seconds
automatically. Back to the functions without any change press the MENU button
again.
Temperature Display
Select the
, press ENTER button and the display will show the temperature of
each unit
....... To go back to the functions press the MENU button.
Firmware version
Select the
, press ENTER button and the display will show the version of
software of the unit. To go back to the functions press the MENU button.
5. How To Control The Unit
You can operate the unit in two ways:
1. By manual controller
2. By DMX controller
No need to turn the unit off when you change the DMX address, as new DMX
address setting will be affected at once. Turn on the unit, if there is DMX or without
DMX and manual mode turn off, the LED will display the saved channel address
（001-512）; If there isn't DMX and manual mode turn on, the LED will display
9A
○
2 LED:
DMX
On
DMX input present
○
3 Button:
MENU
To select the programming functions
To go backward in the selected
DOWN
functions
To go forward in the selected
UP
functions
ENTER
To confirm the selected functions
○
4 Mains input/output:
Connect to supply mains power, and Connect to supply mains power for the next
unit.
○
5 Fuse: 10 A
○
6 DMX input/output:
For DMX512 link, use 3/5-pin XLR plug cable to input DMX signal, and to link the
next unit.
4.2 Main Function
To select any functions, press MENU button until the required one is shown on the
display. Select the function by ENTER button. Use DOWN and UP button to change
the mode. Once the required mode has been selected, press ENTER button to setup
6A
Advertisement
