Technical Specifications; Installation - ACME LED-BL8 User Manual

Enlarged version

1. Connect the fixture together in a "daisy chain" by XLR plug cable from the

output of the fixture to the input of the next fixture. The cable cannot be

branched or split to a "Y" cable. Inadequate or damaged cables, soldered joints

or corroded connectors can easily distort the signal and shut down the system

2. The DMX output and input connectors are pass-through to maintain the DMX

circuit when one of the units' power is disconnected.

3. At last fixture, the DMX cable has to be terminated with a terminator to reduce

signal errors. Solder a 120-ohm 1/4W resistor between pin 2(DMX-) and pin

3(DMX+) into a 3-pin XLR-plug and plug it in the DMX-output of the last

fixture.

4. Each lighting fixture needs to have an address set to receive the data sent by the

controller. The address number is between 0-511 (usually 0 & 1 are equal to 1).

5. 3 pin XLR connectors are more popular than 5 pins XLR.

3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+)

11A

2. Technical Specifications

 DMX 1/2/8/9 channels switchable.

 Smooth 0~100% dimming and variable strobe speeds.

 Two operation modes: DMX, Manual mode.

 Ideal for discotheques, clubs, bars, parties, Mobile DJs, etc.

 Input Voltage:

AC 100V~240V 50/60Hz

 Total Power consumption: 800W

 Fuse:

T10A

 LED:

8 x 65W LED

 Dimension:

885x 515 x 182 mm

 Weight:

16.5Kgs

The unit should be mounted via its screw holes on the bracket. Always ensure

Table of Contents

Stage blinder p8