GE MDS SD4A Technical Manual page 114

RF, chart for converting dBm-Watts-Volts 102
specifications 96
Procedures
checking for alarms (STAT command) 85
downloading new software 89
mounting the transceiver 18
network-wide diagnostics 88, 94, 97
troubleshooting 83–87
Product
description 3, 4
model number codes 7
Protected Network Station
definition of 8
PWR
LED 31
R
Radio
Configuration Software 89
inoperative (troubleshooting chart) 83
no synchronization with master (troubleshooting chart) 84
poor performance (troubleshooting chart) 84
Receiver
specifications 96
system specifications 95
Redundant operation, defined 101
Remote
Station, defined 101
Station, illustrated 17
RTU (Remote Terminal Unit)
defined 101
S
SCADA (Supervisory Control And Data Acquisition),
defined 101
Signal
loss due to coaxial cable length at 960 MHz, table 20
Simplex 11
Sleep mode
shown by PWR LED status indicator 31
Software
diagnostics and control used from PC 89
upgrading 89
Specifications
diagnostics interface 97
environment 96
power 96
receiver 96
receiver system 95
transmitter 95
transmitter system 95
Standing Wave Ratio—See SWR. 102
Supervisory Control And Data Acquisition—See
SCADA. 102
SWR (Standing Wave Radio), defined 102
T
Tables
alarm code definitions 86
conversions, dBm-Watts-Volts 102
LED status indicators 31
length vs. loss in coaxial cables at 960 MHz 20
troubleshooting 83
Technical reference 87–97
Transceiver
ii
Transmitter
Troubleshooting 83–87
SD Series Technical Manual
diagnostics using PC software 89
mounting 26
mounting instructions 18
upgrading software 89
specifications 95
system specifications 95
performing network-wide diagnostics 88, 94, 97
STAT command (Status) 85
table 83
using PC software for 89
MDS 05-4846A01, Rev. F