Com1 Operating Modes; Changing Com1 Modes - GE MDS SD4A Technical Manual

MDS 05-4846A01, Rev. F
Figure 38. Remote Reprogramming Screen

8.3 COM1 Operating Modes

COM1
The port can operate in one of several possible modes. From the
user's perspective, it can be considered to be in Data mode or Manage-
ment mode, where user input can be accepted via either a menu inter-
face, a command line interface, or a diagnostic interface such as GE
MDS-proprietary DLINK protocol. The list below shows all possible
COM1
modes for the port:
• Menu mode—For serial-based "console terminal" control of the
radio. Menu screens are presented where you make selections and
apply them with the Enter key.
• Data mode—Where
control/management of the transceiver.
• DLINK (diagnostics) mode—Where a PC running InSite or
NETview management software is connected to
• Command line/scripting mode—Where text-based commands
are used to manage the radio, typically by means of an automated
"scripting" system, rather than by manual entry. (Refer to SD
Serial/Telnet Management Supplement, Part No. 05-6193A01 for
a summary of text commands.)

Changing COM1 Modes

The Device Manager may be used to change the
Configuration>>Communication Ports>>Com 1 Port Settings
by accessing the
screen (see "COM1 Port Settings" on Page 63). Using this screen, the
Startup Mode Current Mode
and
the drop-down selections.
NOTE: The COM1 operating mode may also be set using a PC
terminal connected directly to the port. See SD Serial/Telnet
Management Supplement, Part No. 05-6193A01 for details.
SD Series Technical Manual
Invisible place holder
COM1
is used for payload data, and not user
COM1
may be set to either
COM1
.
operating mode
Console Data
or from
93