Stp Cable; Control Communications; Features - Extron electronics DTP T USW 233 User Manual

STP Cable

Extron recommends XTP DTP 24 shielded twisted pair (STP) cable for best performance.
Extron recommends at least 24 AWG, solid conductor, STP cable with a minimum
bandwidth of 400 MHz.
ATTENTION:
Twisted pair cable is smaller, lighter, more flexible, and less expensive than coaxial
cable. The DTP 230-enabled products make cable runs simpler and less cumbersome.
Termination of the cable with RJ-45 connectors is simple, quick, and economical.

Control Communications

You can control this device through the front panel USB connector, the rear panel RS-232
connector, or through a DTP matrix. The RS-232 and IR communications are pass-through
only. The switching transmitter and receiver do not generate or respond to the RS-232 and
IR communication signals.

Features

Transmits HDMI or analog video, control, and analog audio up to 230 feet
(70 meters) over a single STP cable — The DTP T USW 233 provides high reliability and
maximum performance on an economical and easily installed cable infrastructure.
HDBaseT compatible — The DTP output can be configured to send video and embedded
audio, plus bidirectional RS-232 and IR signals to an HDBaseT-enabled display.
Inputs — Two HDMI and one RGBHV on 15-pin HD, one 3.5 mm stereo mini jack for audio.
Supports computer video to 1920x1200, including HDTV 1080p/60 Deep Color and 2K —
The DTP T USW 233 supports digital signal transmission up to 230 feet over a single
twisted pair cable and maintains superior image quality at the highest resolutions.
Analog stereo audio embedding — Analog stereo audio signals can be selectively
embedded onto the digital video output signal and transported over DTP. The HDMI inputs
can be set to pass the embedded digital audio, embed the analog audio, or to automatically
embed the analog audio when no digital audio is detected.
Accepts additional analog stereo audio signals — The DTP T USW 233 supports
a direct pass-through connection for stereo analog audio signals for simultaneous
transmission over the same single twisted pair cable. Analog audio is not embedded onto
the digital video signal. A DTP 230 receiver can output balanced and unbalanced audio,
allowing streamlined integration within an AV system.
Bidirectional RS-232 and IR insertion for AV device control — Control and IR signals
can be transmitted alongside the video signal over DTP connections, allowing the remote
device to be controlled without the need for additional cabling. Bidirectional control insertion
eliminates the need for control system wiring to remote devices.
Remote power — For simplified installation, only one power supply is necessary to power
both devices. The switcher can remotely power another connected extender or can be
powered by a connected extender or matrix switcher.
• Do not use Extron UTP23SF-4 Enhanced Skew-Free AV UTP cable or
STP201 cable to link the switching transmitter and receiver. The DTP T USW 233
does not work properly with these cables.
• N'utilisez pas le câble AV Skew-Free UTP version améliorée UTP23SF d'Extron ou
le câble STP201 pour relier les produits XTP avec les émetteurs ou les récepteurs
DTP.
DTP T USW 233 • Introduction 2