Related Manuals for Extron electronics DTP T EU 332
Summary of Contents for Extron electronics DTP T EU 332
- Page 1 User Guide DTP Systems DTP T EU 332 DTP T EU 232 DTP T MK 332 DTP T MK 232 Two-input Universal Twisted Pair Transmitters for EU- and MK-type Junction Boxes 68-2713-01 Rev. A 09 14...
-
Page 2: Safety Instructions
Safety Instructions Safety Instructions • English Инструкция по технике безопасности • Русский WARNING: This symbol, , when used on the product, is intended to ПРЕДУПРЕЖДЕНИЕ: Данный символ, , если указан alert the user of the presence of uninsulated dangerous voltage within the на... - Page 3 “Extron Safety and Regulatory Compliance Guide” on the Extron website. Copyright © 2014 Extron Electronics. All rights reserved. Trademarks All trademarks mentioned in this guide are the properties of their respective owners. ® The following registered trademarks...
-
Page 4: Conventions Used In This Guide
Conventions Used in this Guide Notifications The following notifications are used in this guide: ATTENTION: • Risk of property damage. • Risque de dommages matériels. NOTE: A note draws attention to important information. A tip provides a suggestion to make working with the application easier. TIP: Software Commands Commands are written in the fonts shown here:... -
Page 5: Table Of Contents
Operation ............17 Indications ............ 17 Switch Modes..........17 EDID ............. 17 Reset ............17 Troubleshooting — If no Image Appears ... 18 DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Contents... - Page 6 DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Contents...
-
Page 7: Introduction
(STP) cable (recommended) or other STP cable. The DTP T EU 332 and DTP T MK 332 are compatible with a DTP HDMI 330 Rx or DTP DVI 330 Rx receiver, with a range of up 330 feet (100 M). - Page 8 DTP T EU 332 Transmitter Two Input DTP Transmitter for EU-type Junction Boxes Inputs Figure 1. Typical Transmitter and Receiver Application DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Introduction...
-
Page 9: Features
Transmits HDMI or analog video, control, and analog audio up to 330 feet (100 meters) (DTP T EU 332 or DTP T MK 332) or 230 feet (70 meters) (DTP T EU 232 or DTP T MK 232) over a single STP cable — The units provides high reliability and maximum performance on an economical and easily installed cable infrastructure. -
Page 10: Installation And Operation
Installation and Operation This section contains information for mounting, connecting, wiring, and operating the DTP T EU 332, DTP T MK 332, DTP T EU 232, and DTP T MK 232 . Topics in this section include: • Installation Overview •... - Page 11 Mounting the Switching Transmitters … page 9). Connect inputs to the front panel connectors (see Front Panel Connectors … page 10). DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Installation and Operation...
-
Page 12: Installing The Junction Box Or European Cable Channel System
Le blindage tressé et le blindage en aluminium devraient être connectés à la masse d’un équipement à l’autre bout du câble. DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Installation and Operation... -
Page 13: Rear Panel And Side Panel Features
If commands are sent simultaneously to both, the command that reaches the processor first is handled first. DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Installation and Operation... - Page 14 Reset button — The Reset button initiates a reset of the switcher (see RESET Reset on page 17 for details). DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Installation and Operation...
-
Page 15: Mounting The Switching Transmitters
To install the adapter plate to a European cable channel system, refer to the • manufacturer of the European cable channel system for any additional equipment or installation requirements. DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Installation and Operation... -
Page 16: Front Panel Connectors
15-pin HD connector. See VGA connector Wiring on page 13 to for connector pinout. DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Installation and Operation... - Page 17 Present Analog audio No audio HDMI HDMI embedded audio HDMI HDMI embedded audio HDMI Analog audio HDMI No audio DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Installation and Operation...
-
Page 18: Connection And Wiring Details
While holding the connector securely against the lacing bracket, use pliers or similar tools to tighten the tie wrap, then remove any excess length. DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Installation and Operation... -
Page 19: Vga Connector Wiring
Afin de s’assurer de la compatibilité entre FCC Classe A et CE, les câbles STP et les connecteurs STP sont nécessaires. DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Installation and Operation... -
Page 20: Ir And Rs-232 Connector Wiring
The length and preparation of exposed wires is important (see the second and third power connector CAUTIONS on the next page for details). DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Installation and Operation... -
Page 21: Power Supply Wiring
Ne pas étamer les conducteurs avant de les insérer dans le connecteur. Les câbles étamés ne sont pas aussi bien fixés dans le connecteur et pourraient être retirés. DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Installation and Operation... - Page 22 To verify the polarity before connection, plug in the power supply with no load and check the output with a voltmeter. DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Installation and Operation...
-
Page 23: Operation
6 seconds. All front panel LEDs cycle. Release the button. This reset is the equivalent of issuing the Reset SIS command ( ZXXX , see page 25). DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Installation and Operation... -
Page 24: Troubleshooting - If No Image Appears
Call the Extron S3 Sales & Technical Support Hotline if necessary. See the of this guide for the phone number in your region of the world. DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Installation and Operation... -
Page 25: Remote Control
TP function switch is Hdbt changed. n is the switch position; = HDBT, = DTP. DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Remote Control... -
Page 26: Error Responses
The ASCII to HEX conversion table below is for use with the command and response table. ASCII to Hex Conversion Table Space • DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Remote Control... - Page 27 1 = verbose mode (default for RS-232 or USB) (default) 2 = tagged responses for queries 3 = verbose mode and tagged for queries DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Remote Control...
- Page 28 = Input number = Always output = HDMI input = VGA input X& = Color bit depth mode = Auto = 8-bit DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Remote Control...
- Page 29 = Raw EDID data 128 or 256 bytes of hexadecimal data = Resolution and rate in plain text Example: 1920x1200 • @60Hz DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Remote Control...
- Page 30 = Not detected, authorized = Detected, authorized NOTE: = Pixel phase – = default) = Total pixels Depends on input rate DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Remote Control...
- Page 31 = Verbose mode = clear/none = tagged responses for queries = verbose mode (default) = verbose mode and tagged for queries DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Remote Control...
-
Page 32: Product Configuration Software
Downloading a Software or Firmware Package (PCS Shown) Click the , or specific firmware package link as appropriate to the Software Firmware operation you are performing. DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Remote Control... - Page 33 (3). For a firmware download, exit this procedure and return to Updating the Firmware on page 30. DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Remote Control...
-
Page 34: Starting The Program
Operate the Product Configuration Software as described in the PCS Help (click > Extron PCS Help DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Remote Control... - Page 35 Figure 19. Product Configuration Software DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Remote Control...
-
Page 36: Updating The Firmware
The original factory-installed firmware is permanently available on the unit. If the attempted firmware upload fails, the unit reverts to the factory-installed firmware. Click to exit the program (4). Finish DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Remote Control... - Page 37 Connect the computer to the Configuration port (see item on page 7) or Remote item RS-232 port (see on page 8) of the switcher. DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Remote Control...
- Page 38 Navigate to the folder where you saved the firmware upgrade file (see figure 21, above). Select the file (3) and click (4). The Update Firmware dialog box returns to the Open top. DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Remote Control...
- Page 39 Starting the Program, beginning at step 3 on page 28. DTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Remote Control...
- Page 40 Extron Electronics makes no further warranties either expressed or implied with respect to the product and its quality, performance, merchantability, or fitness for any particular use. In no event will Extron Electronics be liable for direct, indirect, or consequential damages resulting from any defect in this product even if Extron Electronics has been advised of such damage.
Need help?
Do you have a question about the DTP T EU 332 and is the answer not in the manual?
Questions and answers