Transmitter - Button Functions - Dog trace d-control 500 mini User Manual

Transmitter - button functions

The Dogtrace d–control transmitters are designed to operate with two separate receivers (dog 1 and
dog 2). The selected level of stimulations can be different for each receiver
Button - Tone signal
The receiver emits a beeping noise when a „Tone button" is pressed. If the button is not released after
30 seconds, the tone will automatically turn off. While pressing, an indicator of the radio transmission
will appear on the LCD display of the transmitter; the indicator light on the receiver goes from flashing
green to permanent green for as long as the button is pressed.
Pressing the „Stimulation button" activates a special type of stimulation in the receiver consisting
of safe stimulating impulses transmitted by two contact points installed in the receiver. You can choose
between momentary (nick N) and continuous (C) stimulation (if the button is not released after 4
seconds, the stimulation will automatically turn off as a safety feature). It is possible to adjust the
intensity of the stimulation very easily by the Up/Down control buttons. The receiver will be ready to be
reactivated once the button has been released. While pressing, an indicator of the radio transmission
will appear on the LCD display of the transmitter; the indicator light on the receiver goes from flashing
green to permanent red for as long as the button is pressed. You can select a momentary stimulation
(option N) or a continuous stimulation (option C) by pressing
the selection button repeatedly; if the second receiver is used, press repeatedly the selection
button to select momentary or continuos stimulation.
10