Table of Contents
Advertisement
9.1 Transmitter – button functions
Audible beep tone
When pressing the button for beep tone, the receiver on dog's collar begins to emit
an audible beep tone (an acoustic signal). This command can precede a vibration
impuls. It is also a very effective warning tool. You can use the acoustic signal
instead of the command: Come!/Heel! In this case it replaces a whistle, the dog
always perceives its sound in the same intensity. It's very important always to use
the beep sounds in the same way in order not to confuse your dog. While
transmitting the audible beep tone, the green LED indicator of the receiver is
emitting a light.
Vibration
The vibration serves mainly to draw attention of sensitive dogs or training dogs
with impaired hearing. Provides a discreet recall of the dog, which is with deaf dogs
virtually impossible. It provides the ability to distract dog from undesirable activities
with moment of surprise. Each mode can mean different commands, depending on
your training. It can also substitute teaching method using the „clicker" and treats.
Mode
Function
0
short vibration
1
vibrates as long as you keep the button pressed
series of interrupted vibrations
2
vibrates interruptedly as long as you keep the button
3
pressed
4
vibrates permanently and releases a sound signal
Mode setting is done by using buttons
LCD, transmission of the vibration is made by pressing the button
Transmission symbol appears on the remote controller LCD and a red LED on the
receiver is lit permanently.
Light
For an easy localization of your dog in the dark, this function provides 8 different
modes of LED light. The LED - diodes are placed in the transparent receiver housing
of the collar.
Vibration mode selection
/
. Choosen mode is displayed on
.
25
Advertisement
Table of Contents
