Installation; Binding - GRAUPNER 33575 Manual

Installation

Binding

8 / 24
The receiver must be aligned at right angles to the model on the
receiver platform.
The lower surface of the receiver must always be parallel to one
of the model sides.
Prior to installation, remove the sticker on the back of the receiver.
We recommend using double-sided tape No.: S8376 for Gr-18
to fix the receiver in place.
Binding is only possible if the receiver has not been linked with
a bound transmitter since being switched on (red LED lights).
Press the SET button to set the receiver to BIND mode.
If you wish to bind the receiver to a new model memory, this is
the procedure:
 Switch the transmitter's RF section off in the "Basic model
settings" menu (see transmitter manual)
 Switch on the receiver and put it in binding mode, by press-
ing and holding the binding button (green and red LED on
the receiver are flashing)
 Initiate binding in the transmitter's "Basic model settings"
menu.
 If the red LED of the receiver goes out within about 10 sec-
onds, the binding process has been completed successfully.
 Your transmitter/receiver combination is now ready for oper-
ation.
 If the red LED is still lit, the "binding" failed. In this case,
repeat the whole procedure.
33576_jp_V1