Programming The Regulation; Gyro Setting Display - GRAUPNER 33575 Manual

Programming the regulation

Gyro setting display

GYRO SETTINGS
MODE AI/EL (2)CH7
MODE RUDD (2)CH7
>Aileron:
>Elevator:
Rudder :
Factor : (44%)C10
16 / 24
Note
Before you start entering settings for a new model, it is essential to
select the number of aileron servos in the Aileron servos menu point,
and to define the gyro axes and orientation in the New settings menu
point.
MODE
< >
In this point you can select the gyro correction mode (0-3):
0 - no gyro correction
0
0
1 - normal gyro correction (P and D parameter)
0
2 - heading lock mode (I parameter) with suppression
(Outside the suppression area the gyro control is active, in
stick center position acts the heading lock)
3 - Rate mode
(Heading lock acts in stick center position through the
entire area)
NOTE: In Heading lock mode the servos are moved to the center
position if the factor is set to 0%.
Mode switching
The mode can be set separately for AILE/ELEV and RUDD. The
mode can be set permanently or it can be switched through an
assigned channel. Program the selected channel in your trans-
mitter with a switch, the following positions switch the related
mode:
Mode 0
Mode 1
Mode 2
Mode 3
Preparation step by step:
1. Trim the model with the gyro correction off
2. Switch the receiver off and on to save the values as standard
3. Activate the gyro correction
4. The phase trim should not be used!
5. Set the factor for gyro correction, eventually check the val-
ues for the single control surfaces
- 100%
- 50%
0%
≥ 50%
33576_jp_V1