Installation; Fixed-Wing Model; Helicopter Model - GRAUPNER Falcon 12 Manual

Installation

Fixed-wing model

Helicopter model

OK

8 / 36
The receiver must be aligned at right angles to the model on the
receiver platform.
The lower surface of the receiver must always be parallel to one of
the model sides.
Prior to installation, remove the sticker on the back of the receiver.
We recommend using double-sided tape No.: S8376 for Gr-18 to fix
the receiver in place. Also the so-called mirror adhesive tape is suit-
able.
The receiver must be aligned at right angles to the helicopter on the
receiver platform. Prior to installation, remove the sticker on the
back of the receiver. We recommend using double-sided tape (No.
S8376 for Gr-18) to fix the receiver in place. The receiver must be
connected to a stable power supply with at least two power cables.
Comply with the maximum power consumption permitted by the
servos. All connections can be used for this purpose.
This installation position is at the moment not yet relevant,
but in case of later use of the accelerometers (through soft-
ware update) it will be important!
OK

S1035_Falcon_12_jh_V1