Table of Contents
Advertisement
Installation
Binding
8 / 16
Install the receiver so that the connecting cables for the servos and
power supply remain loose, and so that the receiving antennas are
at least 5 cm from all large metal parts or wires. This includes carbon
fiber parts, servos, electric motors, fuel pumps, all types of cables,
etc. in addition to steel parts. It is preferable to install the receiver
away from all other installed parts at an easily accessible location in
the model. Servo cables may not be wound around antennas or run
next to them.
If the fuselages are made of carbon fiber, the ends of the antennas
should extend from the fuselage by at least 35 mm. If necessary,
exchange the approx. 145 m m standard antennas for HoTT receivers
with the 300 mm or 450 mm long antennas No. 33500.2 or 33500.3.
Binding is only possible if the receiver has not been linked with a
bound transmitter since being switched on (red LED lights). Press the
SET button to set the receiver to BIND mode.
If you wish to bind the receiver to a new model memory, this is the
procedure:
Switch the transmitter's RF section off in the "Basic model set-
tings" menu (see transmitter manual)
Switch on the receiver and put it in binding mode, by pressing
and holding the binding button (green and red LED on the
receiver are flashing)
Initiate binding in the transmitter's "Basic model settings" menu
If the red LED of the receiver goes out within about 10 seconds
and the green LED is illuminated, the binding process has been
completed successfully.
Your transmitter/receiver combination is now ready for opera-
tion.
If the red LED is still lit, the "binding" failed. In this case, repeat
the whole procedure.
S1037_S1012_jh_V1
Hide quick links:
Advertisement
Table of Contents
