For Your Safety By Handling The Batteries; Installation Of The Sumd Diversity Receiver - GRAUPNER GR-12L Manual

For your safety by handling the batteries

!

Installation of the SUMD Diversity receiver

8 / 24
CAUTION
• Protect the batteries from dust, dirt, moisture, heat and vibra-
tions. Only use in dry locations.
• Do not use any damaged battery.
• Batteries may not be heated, burned, short-circuited.
• If handled improperly, there is a danger of fire, explosion, irri-
tation and burns.
• Leaked electrolyte is caustic and should not be touched or
come into contact with your eyes. In case of emergency, rinse
with a large quantity of water and consult a Med. Doctor.
• Stock the batteries in dry and fresh conditions.
• Dispose of the battery in the proper disposal centers.
If possible, the SUMD Diversity receiver S1045 should be mounted
using O-rings and M3 screws. The hole spacing is 20 mm in each
case. The S1046 with heat shrink tubing is attached with vibration
damping double adhesive tape S8506.
The SUMD Diversity receiver has to be protected against shock and
vibration and against dust, splash water, etc. But do not pack the
SUMD Diversity receiver too airtight so that it does not overheat
during operation.
Under no circumstances any cables should be bent, wrapped or
passed close to the antenna. Make sure that the cables cannot shift
to lie directly adjacent to antenna during flight.
In the case of carbon fibre chassis, at least the last 35 mm of the
antennas shall be routed outside.
16570.123_V1sh