Free Mixers - GRAUPNER 33575 Manual

Free mixers

FREE MIXER
>MIXER:
FROM CHANNEL:
>TO CHANNEL:
>TRIM:
TRV - : +100%
TRV + : +100%
33576_jp_V1
The HoTT receiver configured as SUMD constantly generates a
digital sum signal from 8 control signals from the transmitter and
makes this signal available at the specified servo socket, which
is receiver-specific. At the time this manual was revised, this
type of signal was being used by several of the latest electronic
applications of flybarless systems, power supplies, etc.
Channel 5 (C5):
The output channel 5 can be used as servo output, as telemetry
port or as voltage measurement. If the voltage measurement is
active, (instead a servo or as telemetry port) only through the
switch described at the begin a maximal voltage of 25.5 V can
be measured through this output. This voltage will be shown in
the display instead the receiver voltage. This way it is possible
to monitor the main battery voltage without using external sen-
sors.
If the channel 5 is not set up as servo but as sensor or voltage mea-
surement, the channel 5 will be automatically assigned on channel
6. The change will be active only after switching the receiver off and
on again.
Note
If the voltage measurement is active, only through the following
described switch a maximal voltage of 25.5 V can be measured
through this output. Never connect a battery to this telemetry port
without this switch!
<- Channel 5
Note
If you wish to use the gyros, you must always set the tail type to 'nor-
mal' in the transmitter's model type menu.
If your model is a delta, features a V-tail, or has two elevator servos,
< >
you must use the receiver mixer - not the transmitter mixer - to con-
1
trol these control surfaces, since the gyro stabilization system will
1
have no effect on these servos otherwise.
6
+0%
The four receiver mixers work 'downstream' of the gyros.
If you have already programmed mixer functions in the "Wing mix-
ers" or "Free mixers" menu of your HoTT transmitter, you must ensure
that those mixers do not overlap with those available in this menu!
11 / 24