GRAUPNER 33575 Manual page 12

Programming examples
FREE MIXER < >
>MIXER:
FROM CHANNEL:
>TO CHNNEL:
>TRIM: +0%
TRV - : +100%
TRV + : +100%
12 / 24
MIXER:
Up to four mixers can be contemporaneously programmed .
You can switch between Mixer 1, Mixer 2, ... and mixer 4 in the
"Mixer" line.
The following settings only affect the mixer selected in this line.
FROM CHANNEL:
The signal source (or source channel) is mixed in to the target
channel (TO CHANNEL) with a programmable amount. The
method of setting up the values is analogous to the "Free mix-
ers" menu in HoTT transmitters.
TO CHANNEL:
Part of the source channel signal (FROM CHANNEL) is mixed
into the target channel (TO CHANNEL). The mixer ratio is deter-
mined by the percentage values entered in the "TRAVEL-" and
"TRAVEL+" lines. Select "0" if you do not require the mixer.
Mixer ratio (TRAVEL-/+): in these two lines you can define the
mixer ratio in relation to the source channel (FROM CHANNEL);
the value is set separately for both directions.
V-tail with rudder differential
FREE MIXER
>MIXER:
1
3 FROM CHANNEL:
>TO CHANNEL:
4
>TRIM:
TRV - :
TRV + :
Differential is not normally necessary with this tail type. Mixer 3
is not required if you do not need rudder differential, and TRAVEL
for mixer 2 must then be set to -100%.
Alternatively you may prefer to carry out the programming using
the transmitter menu. A 'Rudder / elevator' mixer can be set up
at the transmitter instead of 'Free mixer 3' at the receiver; the
mixer should be set up asymmetrically, e.g. +30%, -30%. This
option frees up one mixer at the receiver.
< > FREE MIXER
2 >MIXER:
4 FROM CHANNEL
3 >TO CHANNEL:
+0% >TRIM:
-60% TRV - :
+100% TRV + :
< >
3
4
4
+0%
+100%
+60%
33576_jp_V1