Programming The Axes Sensitivity - GRAUPNER 33575 Manual

Programming the axes sensitivity

GYRO SETTINGS
MODE AI/EL (2)CH7
MODE RUDD (2)CH7
>Aileron: (2)CH9
>Elevator: (3)CH8
Rudder :
Factor : (44%)CH10
18 / 24
Some transmitters allow the corrective factors to be altered
during a flight using the proportional controls, whereas others
allow fixed values only.
Flight phase specific settings
It is possible to use a channel to control the factor value by set-
ting up flight phase specific transmitter control settings, but only
with mx-20 / mc-20 / mc-32 / MZ-24PRO; please see the
instructions supplied with your transmitter and refer to the
"Transmitter control settings" and "Flight phase settings".
Programming through transmitter with proportional controls
< >
If your HoTT transmitter is equipped with proportional controls,
it is also possible to adjust the value for each axis during a flight:
what you might call 'flying the settings'. You need to assign pro-
portional controls to any channel in the range 5 to 16 (in this
example channel 9); now you can alter the value using these
6
controls. The actual value will be shown between parenthesis.
Procedure, using the ailerons as an example: step by step:
1. Move the cursor to the appropriate line, in this case "Ail" for aile-
ron.
2. Press the SET button to activate the Channel field.
3. Select the appropriate channel and save the setting with press-
ing the SET button again
4. Move the related proportional control to change the value (range
between 0 and 10, where 0 means no gyro correction for the
related axe).
5. This value can also be changed by pushing the left or the right
button. This frees up the channel previously occupied by the
proportional control, So that it can be used for some other pur-
pose, e.g. for elevator or rudder.
6. Move on to elevator and / or rudder, and select the channel and
value (you can either select the same channel, in order to alter
all the axes simultaneously, or different channels, allowing you
to program the axes individually).
7. Now test-fly your model and fine-tune the values one by one
until your preferred stabilizing effect is achieved without the
model oscillating.
8. It may be sensible or easier to activate the gyro for one axis only
at first, and then to establish the optimum setting for that axis,
rather than for several axes simultaneously.
33576_jp_V1