Assembly; Main Frame ( - Exerpeutic 1318 Owner's Manual

ASSEMBLY

Tool:
Multi Hex Tool with Phillips
Screwdriver
STEP 1
1a. Installing the Front Stabilizer –Lift up the front of the Main Frame (1), and then align
the holes of the Front Stabilizer (2) with the holes on the front curve of the Main Frame
(1). Insert Two Carriage Bolts (34) into the square shaped holes of the Front Stabilizer
(2) until the threads reach all the way through to the other side. Attach two Washers (36),
two Spring Washers (80), and two Cap Nuts (35) to the threaded side of two Carriage
Bolts (34). Use the Multi Hex Tool with Phillips Screwdriver to tighten the Cap Nuts
(35) until firm and secure.
Note: The wheels on the Front Stabilizer (2) should not be touching the floor when
installed, the wheels should only touch the ground when the unit is tilted forward for
transporting.
HARDWARE PACK
(80) Spring Washer
(36) Washer
(34) Carriage Bolt 2 (35) Cap Nut M8
2 PCS
2 PCS
PCS 2 PCS
10