Configuration Of Rs 232 Interface - sauter FH-M 1 kN Instruction Manual

Auto-Peak-Hold-Mode (Auto-Peak Mode)
To change, please press:
Minimum peak limit function to activate storage of measurements
This function allows to eliminate unwanted „Pre-Peak values" which are lower than
the main peak value (Fp). The pre-setted limit value (Fo) takes care, that those "Pre-
Peak values" are not saved.
The „Min. peak limit value " function is only possible in Peak-Mode.
To set this Min. limit value, please see the SET Menu in section „Operation keys".
Storage of Peak limit values and Average value calculation
(out of up to 10 measurement values)
Saving Peak values in the instrument
 Activation of „AUTO PEAK Function" by PEAK button
 Deactivation of „Average Function" by MEMORY button
 Now, all peak values are stored automatically in the instrument's memory
 To browse through the stored values, please use the ▲ or ▼ keys.
(The values will be shown in the upper display segment)
 By pressing the MEMORY key, the average value of the stored peak values can
be displayed (to be seen in the upper display segment)
 To delete every stored value, press the▼-key in the AVERAGE-Mode

7 Configuration of RS 232 interface

SUB-D 9pm
8 FH-M-BA-e-1718