sauter FH-M 1 kN Instruction Manual page 6

SET:
1 x Press: Upper Limit value [HidT / Hi Lt]. To change, press: ▲ or ▼
-
(see section High/Low Limit function)
-
Hi Lt
1 x Press: Lower Limit value [LodT]. To change press ▲ or ▼
-
(see section High/Low Limit function)
Lo dT
- 1 x Press: Minimum limit value to activate memory function at limit value
measurements (PEAK). [LE.SET / Lo Pe] (also see section „Min Peak Limit
value function)".
To change, press: ▲ or ▼ (Only active in „Peak-Mode", see section limit
-
value indication)
Lo Pe
- 1 x Press: Sets the Auto-STOP force value that stops the movement of the
test stand when reaching a limit force. Adjustment of the force limit.
To change, press: ▲ or ▼
-
StoP
- 1 x Press: Auto-OFF Function. Turns the instrument off after a here defined
period of time in sec. [P.OFF]. To change, press: ▲ or ▼
(Only active in „battery-Mode")
P.OFF
- 1 x Press: Peak-Freeze-Time [PE.2E / A.PE / HoldT]: period of time (in
sec.) in which a peak value is being shown in the display (PEAK).
To change press: ▲ or ▼
-
HoldT
- 1 x Press: Optional data transfer [rS232] to PC (PC) or to the printer (Print)
or (in version U 5.3) to the test stand (stand)
rS232
- PC: Pressing SET 1x: Saves the Settings
- PRINT: Pressing SET 2x: sending data to the printer
- STAND: Pressing SET 3x: sending a signal to the test stand
to stop the movement (in version U 5.3)
6 FH-M-BA-e-1718