System Power - Pitney Bowes DM125 Operator's Manual

Safety

System Power

Use the power cord supplied with the machine chassis at the power entry and plug it into a
l
properly grounded (earthed) and easily accessible wall outlet located near the machine. Failure to
properly ground (earth) the machine can result in severe personal injury and/or fire.
The power cord wall plug is the primary means of disconnecting the machine from AC power
l
supply for Lock Out/Tag Out.
DO NOT use an adapter plug on the line cord or wall outlet.
l
DO NOT remove the ground pin from the line cord.
l
The machine will be connected to a dedicated AC power line.
l
DO NOT route the power cord over sharp edges or trap it between furniture.
l
Ensure there is no strain on the power cord where it becomes jammed between the equipment,
l
walls or furniture.
Be certain the area in front of the wall receptacle into which the machine is plugged is free from
l
obstruction.
Ensure there is no strain on the power cord where it becomes jammed between the equipment,
l
walls or furniture.
For Input modules and Output modules - power is distributed from the chassis. Use the AC
l
connectors supplied with the modules to connect to system power. Do not connect external
devices to the inserter.
Pitney Bowes Operator Guide February, 2017 Page 13 of 226