Ml 80 Wireless Headphones - Minelab EQUINOX 600 Instruction Manual

Contents
ML 80 Wireless Headphones
Wireless Bluetooth® aptX™ Low Latency headphones can be connected to EQUINOX for
fast clear wireless audio and greater detecting freedom.
EQUINOX 800 is supplied with Minelab ML 80 Bluetooth® aptX™
Low Latency headphones. These headphones are also available
separately as an accessory and are compatible with EQUINOX 600.
Headphone Socket
USB Mini-B
3.5 mm (1/8-inch)
Socket
Pairing Wireless Headphones
Pairing the ML 80 headphones is only required at first time use.
EQUINOX will then automatically connect to the headphones for
all future uses.
Re-pairing will be required if a different wireless device has been
connected to the detector (e.g. WM 08), or following detector
factory reset.
1. Ensure your wireless headphones are turned off and are no
more than 1 metre (3-feet) away from the detector.
2. Press and hold the Multi-Function button on the ML 80
headphones until two ascending tones are heard and the LED
alternates blue and red.
3. Press the wireless button on the side of the EQUINOX control
panel for 5 seconds until the Wireless icon starts to flash rapidly.
For first-time use of the EQUINOX, or following a factory reset, a
short press of the Wireless button will immediately start the pairing
sequence.
4. The EQUINOX first attempts to pair with a WM 08 module for
15 seconds, indicated by the Wireless icon flashing on the LCD.
If a WM 08 is not found within this time, EQUINOX will then
attempt to pair with Bluetooth® headphones for 5 minutes, or
until pairing is complete. This is indicated by the Bluetooth®
icon flashing on the LCD.
The Pairing process can be interrupted at any time by pressing
the Wireless button.
5. If pairing is successful, the Bluetooth® and Wireless icons on the
LCD will remain steady on. The headphones will beep and the
Status LED will flash blue once every 3 seconds.
If the pairing is not successful within 5 minutes of being
initiated, the headphones will go into standby mode.
Turning Wireless Off
A short press of the Wireless button when wireless is active will
switch Wireless off.
Wireless Headphone Connection Icons
Status LED
These icons appear on the top right of the LCD and show the
wireless audio devices currently connected to your detector.
Plus Button (+)
Multi-Function Button
Minus Button (–)
ML 80 Status LED
Unpairing the ML 80 Headphones
Wireless headphones can be unpaired in the following ways:
• Factory reset of the detector
• Factory reset of headphones
• Attempting to connect a different wireless device of the same
type (e.g. other Bluetooth® headphones). It is not possible to
operate both the WM 08 and Bluetooth® headphones at the
same time.
Adjusting ML 80 Volume
The ML 80 headphones have their own volume control, which is
independent of the detector volume.
Press the Plus (+) or Minus (–) buttons on the headphones to
increase or decrease volume.
ML 80 Wireless Headphones | 56
Standard Bluetooth® headphones connected
aptX™ Low Latency headphones connected
Turn Wireless off when you are not using it to conserve
detector battery life.
Pairing (Alternating blue and red)
Connected (Flash every 3 seconds)
Headphones on, Not Connected (Flash every 2 seconds)
Charging
Charging complete (Off )