Minelab Equinox 600 Getting Started Manual

Assembly | Follow the steps to put together your EQUINOX Series detector
1. Attach coil to lower shaft
1. Insert the two rubber washers into the holes
on either side of the yoke.
2. Slide the yoke into the yoke bracket on top of
the coil.
Ensure that the spring loaded pin in the lower
shaft is underneath.
3. Insert the plastic bolt through the yoke and the
yoke bracket.
4. Fasten with the plastic bolt - Do not
overtighten.
2. Assemble shafts
1. Loosen the twistlocks by rotating them
counter-clockwise.
2. Press the spring loaded pin in the lower shaft
and slide it into the middle shaft until the pin
reaches the adjustment holes. The pin will click
into place.
3. Attach the middle shaft to the upper shaft in
the same way.
4. Lock the position of the shafts by rotating
twistlocks clockwise.
Audio
EQUINOX Series detectors have an external
loudspeaker for detecting without headphones.
A range of other audio options are available. Please
refer to the full instruction manual for further
information, including wireless options.
4
3
2
1
1
2
3
4
Charge battery
EQUINOX Series detectors have an internal Li-Ion rechargeable battery. Before first use, it is recommended
that you fully charge the battery. For fastest charge time, turn the detector off during charging.
1. Connect the magnetic charging cable USB connector to any standard powered USB port.
2. Connect the magnetic charger connector to the socket on the rear of the detector user interface. The
Charge Status LED at the top left of the user interface will flash steadily.
3. When charging is complete, the Charge Status LED will remain on.
3. Attach armrest/stand
1. Place the armrest onto the top of the upper
shaft. Position the armrest just below your
elbow, then line up the central hole in the
armrest with the nearest hole in the shaft.
2. Insert the screw through the stand, upper shaft
and armrest. Tighten the screw carefully.
3. With the velcro side facing upwards, thread
the armrest strap through both slots in the
armrest. Ensure the end of the strap will be
fastened outwards from your arm.
4. Connect coil
1. Wrap the coil cable around the lower and
middle shaft enough times to take up the
slack.
2. Use the velcro tabs provided to secure the coil
cable against the shaft.
3. Align the coil connector and plug into the
socket in the back of the control box, lightly
tightening the retaining ring.
2
1
3
1 2
3